Sea-Doo PWC GT, GTI, GTS, GTX Vinyl Replacement Standard Seat Cover

Description

Visit our store
CONTACT US
Sea-Doo PWC GT, GTI, GTS, GTX Vinyl Replacement Standard Seat Cover
Item Description
Sea-Doo PWC Yellow and Light Gray Vinyl Replacement Seat Cover
Replacement vinyl seat cover
Made from high quality marine vinyl and designed to last for years
Custom fit to specified models
Yellow and light gray colors
Installation is easy and can be done by most do it yourselfers - please read installation guide below application chart
Seat cover only - does not include seat frame, foam, straps or any other accessories
No refunds or exchanges on any seat cover that has been installed
Color samples may view differently than actual color, depending on monitor settings
Please check the application chart below for specific models this part fits
Application Chart
Model
Year
GT
(Standard Flat Seat)
1990 - 1991
GTI
(Standard Flat Seat)
1996
GTS
(Standard Flat Seat)
1992 - 2000
GTX
(Standard Flat Seat)
1992 - 1995
Tools needed for installation
Staple gun (preferably electric or air powered)
Stainless steel 1/4" staples to fit your gun
Needle nose plyers
Flat blade screwdriver or other type of tool to pry out staples
Scissors
Utility knife
Some seats have straps, handles or brackets that may require additional tools
Most seat covers are designed to be installed over your factory cover. The old cover may need to be removed or sections of it removed if it is torn or damaged. If the original is badly damaged or the seat foam is wet you should remove the cover completely and let the foam dry before installing the new cover.
If the foam is damaged you will need to repair it before installing the new cover or the damage will show through. Small cracks can usually be repaired with duct tape to hide the damage. Larger repairs can be made by replacing the damaged foam and then sanding the new foam to match the shape of the old foam. If your seat has extensive damage we recommend taking it and your new cover to a local upholstery shop.
Installaion of the cover is easiest if the vinyl is warm - a nice sunny day, a warm shop or a hair dryer can accomplish this. Make sure you do not have any sharp corners or protrusions before installing.
Align the cover onto the seat so that it is centered over the main section of the seat. Put a staple at each corner or curve including the front of the seat (these staples may need to be removed later as you stretch the material into place). Once you have the material aligned you can continue stretching and fitting the cover around the seat. As you staple and stretch it may be necessary to trim away excess material. You will want to use many staples around the perimeter of the seat - use the original as your guide. After the cover is completely stapled in place you should trim away any excess material.
On some models with a strap you can reinstall the strap at this time if you prefer.
Store Categories
Anchor & Docking
Electronics & Instruments
Fishing
Fuel & Ventilation
Hardware & Fasteners
Inboard & I/O Motor Parts
Lighting
Outboard Motor Parts
Plumbing, Bilge Pumps & Aerators
Propellers
PWC Parts & Accessories
Safety
Seats, Ladders & Accessories
Steering & Controls
Tools - I/O, Outboard & PWC
Tops & Covers
Trailer Parts & Accessories
Trolling Motors, Parts & Accessories
Water Sports
Wiring & Electrical
Other
WHITE'S MARINE - SHOPWMS
Copyright ©
WHITE'S MARINE - SHOPWMS